Repair 4D Samsung V5-9 Strain Relief
Among the more common issues is a crack or separation in the strain relief. This problem occurs most often where the probe attaches to the cable, but also can occur at the transducer connector.
This problem is easy to spot, as shown in the picture on the right. This is one of the most important problems to address quickly because eventually it will affect your image. Ultimately you will damage the wires inside the cable and it will result in image dropout or complete loss of the ultrasound image.
Solution
Replace the strain relief
Other hot models we can repair:
| Brand | Model |
| Aloka | UST-52101 |
| Aloka | UST-52105 |
| Aloka | UST-5299 |
| Aloka | UST-5412 |
| Aloka | UST-5413 |
| Aloka | UST-9118 |
| Aloka | UST-984-5 |
| Aloka | UST-9123 |
| Aloka | UST-9124 |
| Aloka | UST-9130 |
| Biosound Biosound | CA541 |
| Biosound Biosound | CA621 |
| Biosound Biosound | CA431 |
| Biosound Biosound | CA123 |
| Biosound Biosound | LA523 |
| Biosound Biosound | EC123 |
| Biosound Biosound | EC1123 |
| Biosound Biosound | PA230E |
Common ultrasound Probe Damage(Specialty 3D/4D Volume probes)
| Common ultrasound probe damage | Solutions |
| Lens cap damage | Lens cap replacement |
| Fluid and oil leaks | Lens cap replacement, oil reservoir repair and replacement |
| Cable cuts | Cable patches, possible cable replacement |
| Inoperative steering | Motor repair |
| Connector housing electrical damage | Minor electrical repairs, pin module replacement |
| Weak or dead elements, dropouts in an image | Array ball replacement, oil reservoir repair and replacement |
We provide repair service on most common probes, 3D/4D transducers, and Endo/TEE probes.
With 10 years experiences on probe repair, our technical engineer team own the most advanced probe repair processes, which enables us to fix probes from a basic lens fault to 4D /TEE fault.
Once repaired, all probes will go through an extensive testing process ,until reach their optimal condition.
FAQ
How to identify a defective probe?
If the probe has a broken membrane or cracked wire, you can see it immediately. But what if the defect is not noticeable?
Ultrasound probes send and receive ultrasonic signals into the body and create an image. If that image has any dropouts, your probe might have defects.
The most commonly occurring problems are related to wiring sheath or membrane. But you can also get a connector refurbishment, crystal replacement, and more.
Tee transducers are particularly expensive ones and usually get bitten by patients. The tiny defects on tee probes are tough to notice.
You can identify the defects by simple monitoring, such as looking for bite marks, corrosive parts, or crushed tubes.
Even a small defect in the Tee probe could be severe for patients. If at all you have a defective tee probe, PRS can lend you one while repairing yours.
Product Tags:
|
|
4D Samsung V5 9 Ultrasound Probe Repair Replace Strain Relief Images
|
